How do I maintain my heater?
This simple checklist will help you maintain your furnace. Clean or replace your filter. Make sure blower motor is functioning correctly. Reduce home’s heating load. Make sure all household vents are free. For gas furnaces, verify the exhaust flue to the outside is clear. Remove all flammable objects from around your furnace. Click to see…
This simple checklist will help you maintain your furnace. Clean or replace your filter. Make sure blower motor is functioning correctly. Reduce home’s heating load. Make sure all household vents are free. For gas furnaces, verify the exhaust flue to the outside is clear. Remove all flammable objects from around your furnace. Click to see full answer. Also asked, do you need to service your furnace every year?Your furnace needs to be checked at least once every year to ensure that it is in proper functioning condition. In fact, furnace manufacturers themselves recommend annual inspections as well as maintenance by a technician. In addition, their warranty terms are clear about damage that is caused by improper maintenance.Also, how do I clean my furnace? How to Clean a Gas Furnace Turn off power/gas to the furnace. Turn off power to the furnace at the breaker box. Clean furnace surfaces. Wipe exterior surfaces with a damp rag. Remove the blower. Carefully clean the blower. Clean the pilot or hot surface igniter. Clean the flame sensor. Inspect the drive belt. Lubricate (but not too much). Simply so, how often does a furnace need to be cleaned? Probably not, but it’s recommended. The best analogy is going to the dentist every six months for a checkup and cleaning; probably not necessary, but recommended. Some HVAC contractors recommend getting newer furnaces checked every other year, but once they’re more than 10 years old, have them checked annually.How do I tune up my furnace? 12 ‘Must-Dos’ on a Furnace Clean and Tune Check the igniter by using an ohmmeter. Check the flame sensor (if present). Pull and clean the burners. Inspect the heat exchanger for excessive rust, cracks, or holes. On condensing 90%+ furnaces, blow out the condensate line. Check the system static pressure. Perform a combustion analysis.
